From 0b9d2e40cc7379a4ad00dc198f755748eb654b49 Mon Sep 17 00:00:00 2001 From: =?UTF-8?q?Pali=20Roh=C3=A1r?= Date: Sun, 31 Oct 2021 16:07:05 +0100 Subject: [PATCH 47/90] dt-bindings: Add 'slot-power-limit-milliwatt' PCIe port property MIME-Version: 1.0 Content-Type: text/plain; charset=UTF-8 Content-Transfer-Encoding: 8bit This property specifies slot power limit in mW unit. It is a form-factor and board specific value and must be initialized by hardware. Some PCIe controllers delegate this work to software to allow hardware flexibility and therefore this property basically specifies what should host bridge program into PCIe Slot Capabilities registers. The property needs to be specified in mW unit instead of the special format defined by Slot Capabilities (which encodes scaling factor or different unit). Host drivers should convert the value from mW to needed format. Signed-off-by: Pali Rohár Signed-off-by: Marek Behún --- Documentation/devicetree/bindings/pci/pci.txt | 6 ++++++ 1 file changed, 6 insertions(+) diff --git a/Documentation/devicetree/bindings/pci/pci.txt b/Documentation/devicetree/bindings/pci/pci.txt index 6a8f2874a24d..b0cc133ed00d 100644 --- a/Documentation/devicetree/bindings/pci/pci.txt +++ b/Documentation/devicetree/bindings/pci/pci.txt @@ -32,6 +32,12 @@ driver implementation may support the following properties: root port to downstream device and host bridge drivers can do programming which depends on CLKREQ signal existence. For example, programming root port not to advertise ASPM L1 Sub-States support if there is no CLKREQ signal. +- slot-power-limit-milliwatt: + If present, this property specifies slot power limit in milliwatts. Host + drivers can parse this property and use it for programming Root Port or host + bridge, or for composing and sending PCIe Set_Slot_Power_Limit messages + through the Root Port or host bridge when transitioning PCIe link from a + non-DL_Up Status to a DL_Up Status. PCI-PCI Bridge properties ------------------------- -- 2.34.1